JLT Next Generation Cold Air Intake Kit for 2003,2004 Cobra available in black textured plastic. This replaced our original Cold Air kit in January 2012.

Intake Tube
Using the original JLT CAI as a guide, we molded, sculpted and perfected everything until we had the best looking, fitting and performing system you can buy. The JLT tube is 4 1/4 inch ID, roto molded plastic to resist engine heat and keep the Intake air charge nice and cool. No Metal Tubing Here!!

MAF and filter relocated into fender well for a cooler Intake charge and can support up to 550 RWHP.

Molded In MAF
The best part of this new JLT Cold Air is we kicked the cool factor up a notch and molded a 105mm MAF housing right in the tube. Now you have a kit you can grow into and not have to buy a Complete new kit when you reach over 550 RWHP.

Putting a Whipple or Kenne Bell blower on your 03, 04 Cobra? Simply drill out the pre molded plug on the MAF block located on the bottom of the tube, discreetly out of sight. Install your SCT MAF 2600 or 3000 sensor electronics, add our huge 4.5 X 12 inch S and B Powerstack filter and you've now changed your JLT Cold Air Intake into a JLT High Boost 12 inch Intake.

Molding the MAF into the tube makes for a much smoother air flow with no couplers, reducers or separate MAF housing and can support 800 and up RWHP for only the cost of the 12 inch upgrade kit, 60.00. Will not work with stock MAF, SCT 2400 or 2800 MAF.

Gains
26-30 RWHP are typical with this kit.

Easy Install
The new Design, detailed instructions and online video instructions helps make this an easy install.

Kit Includes:

• Dry Filter
• JLT Plastic Intake Tube
• Silicone Coupler
• Silicone Reducer
• Apron Plate
• 4x6 S and B Powerstack Air Filter
• MAF Adapter
• MAF Adapter Gasket
• HD Clamps and all needed hardware

Note:

• Uses stock Mass Air Meter
• Will not fit with most strut tower braces or aftermarket K-Members.
• This kit is street legal in all US states.
• CARB Exempt ID: D-761-2