821629Q1 Aluminum Drive Shaft Housing Anode, MerCruiser Alpha One Gen II

• Secures to the bottom of your Alpha One Gen II Drive
• Produced to meet Mercury Marine original equipment manufacturer specifications to best protect your MerCruiser Alpha One Gen II Stern Drive and engine
• Inspect anodes periodically for best protection and replace when seeing signs of corrosion or pitting to help keep your maintenance costs down
• Don’t let corrosion damage your MerCruiser stern drive or engine and reduce your boating pleasure
• MerCruiser anodes meet or exceed mil-spec MIL-A-24779(SH) providing longer lasting protection than zinc anodes and are for us in fresh or salt water

Mercury Quicksilver 97-821629Q 1 - Anode-drive Shaft Housing - Gen II replaces:

• 18-6099 Sierra Marine
• 18-6080A Sierra Marine
• 18-6080 Sierra Marine
• MR-933 OBR Red Rhino
• 97821629T 1 Mercury Marine
• 12711 GLM

Additional Information

Mercury Engine Fitment Guide

Model                                                                                            Serial Number Range(s)

Alpha One (GEN.II) - MerCruiser Drive                                     0D469859-0K999999

Alpha One (GEN.II) 1998 AND UP - MerCruiser Drive.           0L100040-Up

Fit the correct anode material for the waters in which your vessel operates

As a general rule, owners should fit anodes appropriate for the environment in which they most frequently berth, and the infomation below serves as a useful guide:

• Saltwater vessels should use Traditional (Zinc) Anodes
• Brackish water Vessels should use Premium (Aluminum) Anodes
• Fresh water vessels should use Fresh (Magnesium) Anodes

Some boats will alternate between salt and fresh water. Others are docked in marinas or behind tidal barriers. The water there is contained and likely to be brackish or nearly fresh. To avoid corrosion, boat owners must be aware of the consequences this may have on their vessels.  Boat owners can then install the proper cathodic protection system.

Not all anodes are appropriate for every application. For example, after a period of time in fresh water, the surface of a zinc or aluminum anode will become covered with an off-white crust of oxide, essentially sealing the anode and preventing it from functioning even when restored to saltwater. Zinc anodes have a similar difficulty even in brackish circumstances, however aluminum will continue to perform well in river estuaries and other brackish water areas indefinitely. Because the anode is passive, the next most anodic component in the anode bonding system will begin to sacrifice itself, which might be disastrous.

As a result, it is critical to inspect zinc and aluminum anodes after any trips into fresh water. If necessary, clean or replace the anodes. Martyr recommends that if a vessel is in fresh water for more than two weeks, an alternative anode system suitable for fresh water situations be used.

Magnesium anodes have a much higher driving voltage than zinc or aluminum, making them ideal for use in fresh water. Magnesium anodes will become very active in salt water, where they will likely last only a few months. Protected surfaces can accumulate an off-white calcareous deposit that is difficult to remove.

Magnesium anodes are not intended for prolonged use in salt water, and if you plan to leave your boat in salt water for more than seven days (fourteen days in any given year), you should consider replacing the anodes.